How To Change Hydraulic Fluid In Zero Turn Mower

How to change hydraulic fluid in zero turn mower • ThreeTwoHome

Introduction

Maintaining your zero turn mower is essential to keep it running smoothly and efficiently. One of the most important tasks that you need to do is to change the hydraulic fluid regularly. This will help to prevent damage to the hydraulic system and ensure that your mower performs at its best. In this article, we will guide you through the process of changing the hydraulic fluid in your zero turn mower.

Step 1: Preparation

Before you start, you need to prepare your mower. Make sure that it is on a flat surface and the engine is turned off. Also, remove the key from the ignition to prevent any accidental start-ups. Then, locate the hydraulic reservoir, which is usually located near the back of the mower.

Step 2: Drain the Old Fluid

To drain the old hydraulic fluid, you need to remove the drain plug located at the bottom of the reservoir. Place a container underneath to catch the old fluid. Allow the fluid to drain completely. Then, replace the drain plug and tighten it securely.

Step 3: Refill with New Fluid

Now, it’s time to refill the reservoir with new hydraulic fluid. Check your owner’s manual to find out the recommended fluid for your mower. Then, fill the reservoir with the new fluid until it reaches the recommended level. Be careful not to overfill it.

Step 4: Bleed the System

To ensure that there is no air in the hydraulic system, you need to bleed it. Start by turning the engine on and let it run for a few minutes. Then, engage the mower blades and move the levers back and forth to circulate the fluid. Finally, check the fluid level again and top it up if necessary.

Step 5: Check for Leaks

After you have changed the hydraulic fluid, you need to check for any leaks. Start the engine and let it run for a few minutes. Then, inspect the hydraulic lines and connections for any signs of leaks. If you find any, tighten the connections or replace the damaged parts.

Conclusion

Changing the hydraulic fluid in your zero turn mower is an important maintenance task that you need to do regularly. By following these simple steps, you can ensure that your mower performs at its best and lasts for many years. Remember to always refer to your owner’s manual for specific instructions and recommendations.